Parts for ALL Western Instrument Company floats are interchangeable

#28968 - With 2 carbide chip blades

#28966 - With diamond chip Float Blades

 

SOLD SEPARATELY

#28969 - E-Z Adjustable Float Handle (fits House & Fischer floats)

SPECIFICATION: The solid steel straight float shaft is assembled with a removable wooden handle, float attachments consisting of a 30 degree angular float and a straight steel float, a five-inch long float extension, an EZ handle, and medium grit carbide chip blades. When ordering, specify substitutions of fine grit carbide chip blades, diamond chipblades, or hardened carbon steel blades. The wooden handle assembly can be easily removed from the shaft by thescrew in the end of the handle. After removing the wooden handle replace the screw and washer into the steel shaft. The float can now be used only as a pistol grip with assembly of the EZ handle applied to the steel shaft. If desired, the wooden handle can be left attached, the EZ handle applied, and used accordingly to the operator’s preference. Entireassembly of parts can be repaired or replaced.

OBJECTIVE: Floating is only one dentition procedure to maintain the symmetry of the arcade in an animal’s mouth and to allow for an unimpeded elliptical chewing motion, as well as assist in bit pressure performance and a guide to better animal health. If the arcade is left unattended, the animal can experience vast pain intraorally which can lead to nutritional problems, negative disposition, dental dilemnas and poor performance in the athletic or working animal.

APPLICATION: To augment professional results in floating, it is important to maintain a concise routine to reduce animal stress and resistance. After the animal has been well restrained (see speculum and wedge application), approach the animal with a steady, slow movement to allow familiarity and observation of the operator and float. Slowly insert the float into the mouth of the animal to allow a gradual sensation of the foreign object. Start by floating the upper arcade premolars with the 30 degree angle float head. Initially begin with short, low pressure strokes until the animal accepts the procedure and continue with firm strokes until the floating is accomplished. Hand position adjustment is critical because it influences float head positioning, adjust accordingly to feel and sound. Tooth particles should be visible the full length down the middle of the float blade if the procedure is being done properly. Remove the float occasionally for examination and make corrective adjustments. Equine animals should have a thorough biannual examination of the mouth arcade to denote any abnormalities. During the floating procedure it will be necessary to use different angle heads and possibly different grades of blades (user’s discretion). For proper floating procedures and dentition problems consult a veterinarian acquainted with equine health.